Hi, I'm taking the 1C03 course, and we're required to install Autodesk Inventor 2011. What are the metrics we need to set during the installation? Is it inches, or millimeters? What is the drawing standard? Thanks.
09-01-2010 at 08:15 AM
#2
mike_302
Elite Member
Join Date: Mar 2009
Posts: 1,086
Thanked:
98 Times
Liked:
422 Times
Last year it was millimeters, and Inches is just silly anyways... Put millimeters.
09-01-2010 at 09:30 AM
#3
kevcom
Member
Join Date: Jun 2010
Posts: 36
Thanked:
0 Times
Liked:
Liked 3 Times
thanks!
09-01-2010 at 10:39 AM
#4
forever0zero
Senior Member
Join Date: Jul 2008
Posts: 114
Thanked:
5 Times
Liked:
39 Times
wait what? you use autodesk instead of solid edge now?!
09-01-2010 at 11:28 AM
#5
chappy89
Senior Member
Join Date: Aug 2008
Posts: 275
Thanked:
10 Times
Liked:
149 Times
bout time they got rid of solid edge... such a piece of garbage
McMaster University News and Information, Student-run Community, with topics ranging from Student Life, Advice, News, Events, and General Help.
Notice: The views and opinions expressed in this page are strictly those of the student(s) who authored the content. The contents of this page have not been reviewed or approved by McMaster University or the MSU (McMaster Students Union). Being a student-run community, all articles and discussion posts on MacInsiders are unofficial and it is therefore always recommended that you visit the official McMaster website for the most accurate up-to-date information.