Engineering Technical Electives - MacInsiders - Student-run McMaster University Help Forum

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Regarding Mechatronics technical electives.	Zachary	Academics	2	06-04-2013 01:07 PM
ENG PHYS Technical electives	jntyrhds	Academics	3	06-08-2012 01:14 AM
ENG PHYS Technical electives	jntyrhds	Academics	1	05-14-2012 12:29 AM
Technical Electives (eng)	RyanC	Academics	3	01-09-2012 05:53 PM
Engineering Electives	kanishka	Academics	27	04-19-2010 06:45 PM

Engineering Technical Electives

12-02-2013 at 05:25 PM

smileyface012

Member

Join Date: Sep 2013

Posts: 1

Thanked: 0 Times

Liked: 0 Times

Engineering Technical Electives

Hey guys!
This is mostly for the mechanical engineers.

I'm trying to decide between two tech electives:
Mech Eng 4E03 - MEMS
Mech Eng 4L03 - Industrial Design

I was wondering if anyone had any input about the classes (difficulty level, mark breakdown, professor etc.) Do you need to be good at drawing for the industrial design class?

I would love some help deciding!

Thanks!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

McMaster University News and Information, Student-run Community, with topics ranging from Student Life, Advice, News, Events, and General Help.

Notice: The views and opinions expressed in this page are strictly those of the student(s) who authored the content. The contents of this page have not been reviewed or approved by McMaster University or the MSU (McMaster Students Union). Being a student-run community, all articles and discussion posts on MacInsiders are unofficial and it is therefore always recommended that you visit the official McMaster website for the most accurate up-to-date information.